So the topic that I would like to emphasize is Bus Network which is one of the Network Topology!
BUS NETWORK is a network topology in which nodes are connected in a daisy chain by a linear sequence of buses
Example picture of bus network :
There is a single wire which is having T connectors to connect all the computers with each other to form a network. The wire is basically a dead wire but the part of the wire having computers on its both sides shall not be a dead wire means there will be a current in it. 10 Base-2, 10 Base-5 are the examples of wires used years ago. Any no. of computers can be connected with this type of topology. Bus topology can be seen in the computer labs to connect computers
How computers communicate on a star bus :
When a computer on a typical star bus sends a message, it travels to the hub. If the hub is an active hub, it regenerates the signal and then sends it out via all ports to the rest of the computers on the network. If the hub is a switching hub, it sends the message out via only the port to which the destination computer is attached.
Equipment requirements :
The star bus requires:
At least one hub, as the hub is the basis of the star.
Multiple hubs can be cascaded
The graphic below shows multiple hubs can be cascaded from hub to hub in a multiple hub star bus layout. In addition to the hub(s), a star network requires that each computer have an NIC with an RJ-45 connector (similar to a phone jack, only larger). No terminators are required on a star network, because each cable segment has only two nodes: the computer on one end and the hub on the


No comments:
Post a Comment